Custom 3D printed drill bit index
Preset: Metric drill bit index
Bit set
19 bits: 1 mm to 10 mm
Holes
Rows
Mounting
Labels
Size
About this drill bit index
A 3D printed drill bit index for the set you own. Choose metric or imperial sizes, the number of rows and whether they step up, a stand or a wall plate, and where the sizes are engraved. Every hole is sized to its bit, without learning CAD.
What people make with it
- Metric bench index with 1 to 10 mm bits in 0.5 mm steps on three stepped rows.
- Larger metric index for a 25-piece set, 1 to 13 mm in 0.5 mm steps.
- Imperial wall index with 1/16 to 1/2 in bits in 1/64 steps and a wall plate.
- Flat drawer tray with two flat rows and no back, to lie in a drawer.
Printed holes often come out slightly small. Print a short row first and adjust the hole clearance before printing a large set.
What you can change
- Bit set. Metric bits from 1 to 16 mm in 0.5 to 2 mm steps, or imperial bits from 1/32 to 3/4 in by 64ths, up to 64 bits.
- Rows. One to six rows, smallest bits at the front, either flat or stepped up toward the back by 4 to 30 mm.
- Back. Stand it on a bench, or add a 5 mm wall plate with two countersunk holes for 4 mm screws.
- Labels. Engrave each size beside its hole, each row’s range on its step, both or none, 3 to 8 mm tall.
Printing it
- It prints as it stands, base down, with no supports. The holes are cut straight down, and a wall plate stands upright at the back; its screw holes are small enough to bridge.
- Engraved labels read best with a 0.4 mm nozzle or finer and labels 3.5 mm tall or more.
- Choose your printer and the editor checks that the model fits its bed.
Cost and licence
- Free. Generate and download it without an account.
- Creative Commons Attribution 4.0. You may print it, change it, share it and sell your prints, as long as you credit IteraMesh as its creator. Read the licence
Common questions
How much hole clearance should I add?
Start with 0.4 mm. If bits are tight, raise it; if they lean or fall over, lower it. Printers differ most on small holes, so test the smallest bits first.
Which bits does it hold?
Round-shank twist bits, held by the shank. Hex-shank, reduced-shank and gauge-numbered bits are not covered yet.
How should I fix the wall plate?
Use two 4 mm screws with plugs suited to the wall. The plate is not load-rated; it is meant for a set of bits, not for tools hung from it.
Why does the size change when I change the bits?
Every hole and label needs room, so a longer set or larger labels need a wider or deeper index. Use Fit to my bits to set the smallest size that holds them.
Do I need an account?
No. You can generate and download without one. An account keeps saved configurations so you can return to them.
