Custom rectangular plant saucer and drip tray

Saucer

Measured on the outside.

Rounds all four outside corners. 0 is a square corner.Inside corners: 2.6 mm, the outside radius less the 2.4 mm wall.

Ribs

Ribs lift the pot above water collected on the saucer floor.
Straight ribs run front to back, spread evenly across the width.
How far the ribs rise above the floor. They stay below the rim.
← 160 mm printed width →160 mm
← 160 mm printed depth →160 mm

About this plant saucer

A rectangular plant saucer made to the pot that stands on it, from a small square drip tray to a long tray for a window-box trough. Enter the width, depth and height, round the corners, choose whether to raise the pot on ribs, and download an STL to print. There is no CAD to learn.

What people make with it

Each is 5 mm wider all round than a ready-made rectangular pot. Open one and change it to your own pot. For a round pot, use the round plant saucer.

What you can change

  • Size. From 60 to 420 mm wide, 60 to 320 mm deep and 8 to 60 mm tall, measured on the outside, in millimetres or inches.
  • Corners. One radius rounds all four outside corners, up to half the shorter side. The inside corners follow it, less the 2.4 mm wall. Make it the pot's corner radius plus the margin to keep the gap even all round.
  • Ribs. Two to eight straight ribs, front to back, to lift the pot above the water, and how far they rise. Or leave the floor flat.

Printing it

  • A flat tray with a straight wall and straight ribs: it prints as it stands, with no supports.
  • Choose your printer and the editor checks that the saucer fits its bed.
  • You download an STL or 3MF file, ready for your slicer.

Cost and licence

  • Free. Generate and download it without an account.
  • Creative Commons Attribution 4.0. You may print it, change it, share it and sell your prints, as long as you credit IteraMesh as its creator. Read the licence

Common questions

How big should the saucer be?

Wider and deeper than the base of the pot, so it catches the water that drains out. The default, 160 × 160 mm, takes the rectangular plant pot's default 150 × 150 mm with 5 mm all round; give a pot that drains a lot more room.

What are the ribs for?

They lift the pot slightly above the saucer floor, so it does not stand in the water that collects there. They come in even numbers, so none runs under a pot's middle drainage hole.

Will it fit a pot I already own?

Yes. It is made to the width and depth you enter, so it suits any square or rectangular pot whose base is smaller than the saucer.

Do I need an account?

No. You can generate and download without one. An account keeps your saved configurations, so you can come back to them.