Dummy 13 action figure

Rendered from the file you download.

About this model

A poseable action figure built from an inner jointed frame and an outer armour shell. Ball joints, swivels and hinges throughout give it a very wide range of poses, and its parts snap together.

This is the creator's model-kit version: every frame piece on one runner and every armour piece on another, which helps the many small parts stay stuck to the bed. Snap the pieces off after printing and tidy any nubs with a hobby knife. It is a challenging print, and the creator recommends ABS, ASA or PETG for the frame, since PLA is too stiff and brittle for its joints.

What you need

From the creator’s instructions

In this download

Frame runner and armour runner STLs, holding every part of one figure.

Nothing else to buy: the download prints complete.

Before printing

Print the frame runner in ABS, ASA or PETG; the armour runner can be any filament.
The creator's settings: 0.2 mm first layer, 0.15 mm layers after it, two perimeters, 20% rectilinear infill, no supports and 0.15 mm elephant-foot compensation.
Keep the bed clean and slow the first layer, so the small parts stay put.

Assembly

Snap every piece off its runner and clean up any nubs with a hobby knife.
Assemble the frame, then fit the armour over it, following the creator's step-by-step picture guide on the source page.

How to use it

Pose the figure by moving its joints gently; a joint that is too tight loosens with use.

Read the creator’s full instructions ↗

Licence and attribution

LicenceCreative Commons Attribution 4.0 ↗

The file remains available under its retained source licence. These permissions and obligations come from IteraMesh’s supported licence profile.

Download and print
Modify the model
Use commercially
Share copies
Credit the creator when you share the model or an adaptation

Attribution

Notices retained with this model

The creator asks that credit name the design (Dummy 13), the author (Gabriel Rosiak, soozafone or Lucky 13 Toys), the source and the CC BY 4.0 licence.

A copyright licence covers the file. It does not grant rights to a trademark, design, patent, person’s likeness, or safety-critical use depicted by the model.

Source and provenance

Licensed import

Original creator: Gabriel Rosiak (Lucky 13 Toys) · profile ↗
Source page: https://makerworld.com/en/models/638587-dummy-13-version-1-0
Original download: https://makerworld.com/api/v1/design-service/instance/564186/f3mf?type=download&fileType=3mfstl
Added to IteraMesh: 23 October 2026
Licence checked: 23 October 2026, on the source page
Changes: None — the file is hosted as acquired
File fingerprint: sha256:f55ff…ff48d4

IteraMesh hosts this copy under its licence. Gabriel Rosiak (Lucky 13 Toys) made it; IteraMesh did not.

Printing and safety

File check: Geometry validated before publication
Units: Not stated in stored evidence
Printer and material: Not verified by IteraMesh
Assembly: Not verified by IteraMesh

IteraMesh has not verified this model for a particular printer, material, or safety-critical use. A listing is not a safety certification.

Safety guidance

Many small parts: not for young children.

Report this model