Rendered from the file you download.
About this model
A small hand tool for holding a drill bit, like a pin vise: the bit sits in the ten-sided tip and an M3 screw through its side clamps it in place. The 115 mm handle gives a firm grip for drilling small holes by hand, such as cleaning out holes in prints.
Its pentagonal and ten-sided shapes keep overhangs small, so both parts print without supports. The tip takes a 3 mm bit.
What you need
From the creator’s instructionsIn this download
- Handle and tip STLs.
You also need
- Standard M3 screws; the source does not give their length.
- A 3 mm drill bit.
Before printing
- Print both parts without supports.
- Use millimetre units.
Assembly
- Fit the tip onto the end of the handle.
- Insert a 3 mm drill bit into the tip and tighten the M3 screw in the tip's side to clamp it.
How to use it
- Turn the handle to drill or clean out small holes by hand.
Licence and attribution
The file remains available under its retained source licence. These permissions and obligations come from IteraMesh’s supported licence profile.
Attribution
Penta Drill Bit Holder by Myo-3dp, CC BY 4.0.
Notices retained with this model
- Original design, inspired by Pin Vise by boksbox (https://www.printables.com/model/166455-pin-vise).
A copyright licence covers the file. It does not grant rights to a trademark, design, patent, person’s likeness, or safety-critical use depicted by the model.
Source and provenance
Licensed import- Original creator
- Myo-3dp · profile ↗
- Source page
- https://github.com/Myo-3dp/PentaDrillBitHolder
- Original download
- https://codeload.github.com/Myo-3dp/PentaDrillBitHolder/zip/01a5603858495a3a854cb0451c07ad0ea9ec2487
- Added to IteraMesh
- 23 October 2026
- Licence checked
- 21 October 2026, on the source page
- Changes
- None — the file is hosted as acquired
- File fingerprint
- sha256:21e0b…bf6bda
IteraMesh hosts this copy under its licence. Myo-3dp made it; IteraMesh did not.
Printing and safety
- File check
- Geometry validated before publication
- Units
- Not stated in stored evidence
- Printer and material
- Not verified by IteraMesh
- Assembly
- Not verified by IteraMesh
- Drill bits are sharp: clamp the bit firmly and keep fingers clear of the cutting end.