2026-11-13 · template v1.0.0 · file fd0cc71c…

Made from the exact file you download for revision 1.
Drawer organizer for IKEA ALEX deep drawers — sized for a 292 × 524 mm drawer, 100 mm tall, with four bays for batteries, chargers, cables and tools.
A 100 mm organizer for the deep drawers of the IKEA ALEX drawer unit (36 × 70 cm). Two bays at the front take batteries and chargers, and behind them a wide bay holds coiled cables beside one for small tools.
Sized for a drawer measured at 292 × 524 mm inside at its narrowest (screw heads stand out from its sides), with sides 115 mm high. The organizer comes out 290 × 522 mm and sits below the sides. Measure your own drawer before printing: if it differs, enter its size in Customize and the bays keep their proportions.
At 522 mm deep it is larger than the bed of most desktop printers. Choose your printer on this page to see whether it fits; in Customize, an organizer too large for the bed is split into pieces that each fit, which you print one at a time and set in the drawer together.
IteraMesh is not affiliated with IKEA. ALEX is IKEA’s name for the drawer unit, used here only to say what this organizer is sized for.
| Label | Inside size (approx.) | Position |
|---|---|---|
| Batteries | 145 mm × 208.80 mm | Left · front |
| Chargers | 145 mm × 208.80 mm | Centre · front |
| Cables | 174 mm × 313.20 mm | Left · middle |
| Tools | 116 mm × 313.20 mm | Centre · middle |
How it prints
Straight walls and a flat floor: it prints open side up, with no supports.
Each version keeps its own size, file and license. An earlier version stays available if this one changes.
Generated model license
Full terms ↗CC-BY-4.0, inherited from Compartment Drawer Organizer v1.0.0 and recorded with this revision. It cannot change later.