Portable cable winder

Rendered from the file you download.

About this model

Wind a charging cable into a pocket-sized hexagonal case: fold the cable at its middle into the slot in the spool, close the hinged lid and turn the handle clockwise to reel it in. To use it, pull both ends and the cable runs out again.

It prints in one piece, with the lid and spool already in place and no supports. The three options differ only in depth, 23, 28 or 33 mm, for shorter or longer cables; the creator suggests starting with Medium. The lid is made to close tightly.

What you need

From the creator’s instructions

In this download

One print-in-place winder STL in the chosen size.

Nothing else to buy: the download prints complete.

Before printing

Print without supports; the lid and spool print in place.
Choose the size by the length of the cable you want to carry.

How to use it

Place the cable in the groove at its halfway point and close the lid.
Wind the cable in clockwise with the handle.
Pull both ends of the cable to let it out.

Read the creator’s full instructions ↗

Licence and attribution

LicenceCreative Commons Attribution 4.0 ↗

The file remains available under its retained source licence. These permissions and obligations come from IteraMesh’s supported licence profile.

Download and print
Modify the model
Use commercially
Share copies
Credit the creator when you share the model or an adaptation

Attribution

Portable Cable Organizer / Winder by squinn, CC BY 4.0.

A copyright licence covers the file. It does not grant rights to a trademark, design, patent, person’s likeness, or safety-critical use depicted by the model.

Source and provenance

Licensed import

Original creator: squinn · profile ↗
Source page: https://makerworld.com/en/models/13849-portable-cable-organizer-winder
Original download: https://makerworld.com/api/v1/design-service/instance/23520/f3mf?type=download&fileType=3mfstl
Added to IteraMesh: 24 October 2026
Licence checked: 24 October 2026, on the source page
Changes: None — the file is hosted as acquired
File fingerprint: sha256:5bcad…fe2d7f

IteraMesh hosts this copy under its licence. squinn made it; IteraMesh did not.

Printing and safety

File check: Geometry validated before publication
Units: Not stated in stored evidence
Printer and material: Not verified by IteraMesh
Assembly: Not verified by IteraMesh

IteraMesh has not verified this model for a particular printer, material, or safety-critical use. A listing is not a safety certification.

Report this model