2026-11-13 · template v1.0.0 · file bee96e2e…

Made from the exact file you download for revision 1.
Drawer organizer for IKEA ALEX shallow drawers — sized for a 292 × 524 mm drawer, 50 mm tall, with six bays for sticky notes, clips, erasers, pens, notebooks and cables.
A 50 mm organizer for the shallow drawers of the IKEA ALEX drawer unit (36 × 70 cm). Three small bays at the front take sticky notes, clips and erasers, a bay across the drawer holds pens, and at the back a large bay takes A5 notebooks beside a narrower one for cables.
Sized for a drawer measured at 292 × 524 mm inside at its narrowest (screw heads stand out from its sides), with sides 56 mm high. The organizer comes out 290 × 522 mm and sits below the sides. Measure your own drawer before printing: if it differs, enter its size in Customize and the bays keep their proportions.
At 522 mm deep it is larger than the bed of most desktop printers. Choose your printer on this page to see whether it fits; in Customize, an organizer too large for the bed is split into pieces that each fit, which you print one at a time and set in the drawer together.
IteraMesh is not affiliated with IKEA. ALEX is IKEA’s name for the drawer unit, used here only to say what this organizer is sized for.
| Label | Inside size (approx.) | Position |
|---|---|---|
| Sticky notes | 116 mm × 130.50 mm | Left · front |
| Clips | 87 mm × 130.50 mm | Centre · front |
| Erasers | 87 mm × 130.50 mm | Right · front |
| Pens | 290 mm × 130.50 mm | Left · front |
| Notebooks | 188.50 mm × 261 mm | Left · middle |
| Cables | 101.50 mm × 261 mm | Centre · middle |
How it prints
Straight walls and a flat floor: it prints open side up, with no supports.
Each version keeps its own size, file and license. An earlier version stays available if this one changes.
Generated model license
Full terms ↗CC-BY-4.0, inherited from Compartment Drawer Organizer v1.0.0 and recorded with this revision. It cannot change later.